3G

Follow the steps below to get the video streaming on iPhone.

Scenario:


Step1. Go to the Video Configuration page and configure the stream setting as the parameters below.
Aspect Ratio as 16:9
Video codec as MJPEG for stream1
Resolution as 1280x720
Frame Rate as 5 fps
Quality as 2
Transport as HTTP Transport
The Video settings of 3GPP will need to be configured depends on the bandwidth of your network environment. The configuration just for the reference.


Step2. Go to the HTTP/HTTPS Configuration page and configure the HTTP port, e.g. 2000.


Step3. Configure the Port Forwarding rule in Router. Add the port 2000 to IP Camera’s IP Address.


Step4. Connect iPhone to Internet, via 3G or Wi-Fi.


Step5. Download and install the eKeypad, enable the eKeypad.


Step6. Select ‘Add Video Device…’ in the eKaypad’s main window.


Step7. Set the Manufacturer & Device Model, e.g. Brickcom as Manufacturer and FB-100Ap as the Device Model.


Step8. Fill in the proper information to each column.


Step9. Get the video streaming on your phone.


Note:
*Support single channel simultaneously
*Support to assign different port number for data transmitting.
*Brickcom IP Camera is compatible.
*Refer to http://www.ekeypad.net/eKeypad_Video/Overview.html for more information.